Alba Conversion Kits – Frequently Asked Questions
Will a conversion kit fit my bike?
Hub kits: measure the fork or rear dropout width; rear kits are supplied for a 6- or 7-speed screw-on freewheel or an 8-speed-and-above cassette. Choose a 20, 24, 26, 27.5, 28 or 29 inch wheel; fat kits come in 20, 24 or 26 inch. Mid kits fit 68–73 mm (BSA) bottom-bracket shells. Not suitable for carbon forks; with aluminium or quick-release forks, check the dropouts and axle retention before installation.
Front hub, rear hub or mid-drive motor?
Front hub (FH): light assist in the city, rear gears untouched. Rear hub (RH): better traction for loads, climbs and fat bikes. Mid-drive: fits in the bottom bracket and drives through the chain and gears, for the highest torque on steep climbs.
Do the kits work with disc brakes and V-brakes?
Yes. With disc brakes the rotor mounts on the motor hub.
Is a battery included?
The kits are supplied as complete systems with battery options. Bottle-type batteries mount on the bottle-cage bolts; rack-type batteries (kits ending in F) sit on an illuminated rear-rack mount. The 500RHE Dual standard set comes without battery.
Which power should I choose?
250 W for city riding; it keeps the bike in the EPAC class. 500 W and above for steep climbs, loads and fat bikes, off-road only. Look at torque (N·m) rather than wattage: 32 N·m (250 W), 65 N·m (500 W), up to 160 N·m (1000Mid).
Which class are kits above 250 W?
A bike converted with a 500 W, 750 W or 1,000 W kit is not an EPAC: off-road use only, not for public roads. With 250 W kits the converted bike can qualify as an EPAC only if the complete installation meets the EPAC requirements: assistance is given only while pedalling and cuts off at 25 km/h, and the thumb lever is used only as walk-assist up to 6 km/h. The installer must make sure the converted bike is safe and complies with the rules of the country where it is used.
Can I install the kit myself?
Yes, in five steps: measure, fit the motor, mount the battery, connect, test. Hub kits replace the wheel and install with basic tools; all connections are plug-in, with no soldering. Mid kits need a bottom-bracket tool. Fit the torque washer and torque arm as shown in the manual, and do not change the factory settings.
Do I need a torque arm?
Recommended for 500 W hub kits, where it is available as an option. A torque arm stops the axle turning in the dropout; torque washers come with every hub kit.
How far can I go with a kit?
It depends mainly on battery energy (Wh): at the same voltage and use, range increases with Wh. Lower figure: high assist and city traffic; upper figure: low assist and flat terrain.
Can I ride without pedalling?
No. The motor assists while you pedal; the thumb lever is a walk assist up to 6 km/h.
Does the battery charge when I pedal or brake?
No. Alba kits do not recharge the battery while riding; charge it with the supplied charger.
Can I ride in the rain?
Yes, the electrical system is protected against rain and splashing water. Do not ride through deep water and do not clean the bike with a pressure washer.