Front hub (FH series): rear gears untouched
In FH series kits the motor sits in the front wheel hub. The rear gears, chain and freewheel are not touched, so the rear drivetrain stays as it is. Alba FH kits are 250 W, 32 N·m, with a 36 V Li-ion battery: the 250FH carries the battery on the frame (bottle type), the 250FHF on an illuminated rear-rack mount.
FH series: choice and compatibility
250FH or 250FHF?
Both kits share the motor, controller and display; only the battery mounting differs. The 250FH mounts the battery in the frame triangle on the bottle-cage bolts. The 250FHF mounts it on the rear rack, which suits frames with little space in the triangle, folding or step-through bikes.
Will it fit?
Measure the front dropout width. Choose a 20, 24, 26, 27.5, 28 or 29 inch wheel. A hub motor loads the fork; hub kits are not suitable for carbon forks; with aluminium or quick-release forks, check the dropouts and axle retention before installation, and fit the torque washers as shown in the manual (torque arm optional for 500 W kits).
EPAC class
With 250 W kits the converted bike can qualify as an EPAC only if the complete installation meets the EPAC requirements: assistance is given only while pedalling and cuts off at 25 km/h, and the thumb lever is used only as walk-assist up to 6 km/h. The installer must make sure the converted bike is safe and complies with the rules of the country where it is used.
Browse products
-
-
UnavailableUnavailable